Intumescent mastic and linear gaps

Mastic is for joints and small gaps. How deep it goes matters more than how neat the bead looks.

  • Every seal labelled and photographed
  • BM TRADA / FIRAS-certificated contractors
  • Written price before any work
Get a price

We reply with a written price.

We use these details to reply to you. See our privacy notice.

A linear gap is a long thin one. The commonest is at the head of a block wall, where the blocks stop 10 or 20mm short of the concrete slab above. Another runs down the side of a door frame, between the frame and the wall. A third is a joint between two blocks where the mortar has fallen out.

An open joint along the top of a blockwork wall where it meets a concrete slab
An open joint along the top of a blockwork wall where it meets a concrete slab

What goes in

For a narrow gap the usual detail is a backing of mineral wool pushed in to a set depth, then a bead of intumescent or fire-rated acrylic mastic on top. The data sheet for that product says how wide a gap it was tested at, how deep the backing must be, how deep the mastic must be, and whether it needs doing from one side or both. A 15mm gap in a 100mm wall might need the mastic 15mm deep on both faces. Get any of those wrong and the rating no longer holds.

Mastic is not a filler for big holes. Above a certain size the product needs a batt or board behind it, and some mastics are not tested round pipes at all.

Head of wall gaps

These matter because they are long. A 20mm gap along a 6 metre corridor wall is a lot of open area, and smoke uses it. Where the slab above moves, for example in a newer frame building, the head of wall joint needs a product tested for movement, which is a different system again.

What you see afterwards

A neat bead of white or grey mastic, a label every so often, and a line in the schedule with the length sealed and the product used. Our BM TRADA / FIRAS-certificated contractors do the work, and photos are taken before and after so the depth of the backing is on record.

Seen a hole round a pipe or cable?

Send the postcode and a photo with a tape measure in shot. We will tell you what it needs and what it is likely to cost.

Call 020 3772 6233Get a quote