Fire stopping around pipes

Plastic pipes melt in a fire and leave a clean round hole. A collar or a wrap is what closes it.

  • Every seal labelled and photographed
  • BM TRADA / FIRAS-certificated contractors
  • Written price before any work
Get a price

We reply with a written price.

We use these details to reply to you. See our privacy notice.

Take a 110mm plastic soil stack running down through a concrete floor in a block of flats. In a fire the plastic softens within minutes and drops away, and what is left is a 110mm hole straight into the flat below. Mortar packed round the pipe does nothing about that, because the hole is inside the pipe.

A fire collar is a steel ring with an intumescent lining. It is screwed to the underside of the floor, or to both faces of a wall, round the pipe. When it gets hot the lining swells, crushes the softening plastic and fills the hole. A wrap is the same material in a flexible strip, pushed into the gap round the pipe inside the wall or floor itself.

A round duct coming through a coated batt seal, finished with sealant round its base
A round duct coming through a coated batt seal, finished with sealant round its base

Which one goes where

That depends on the pipe size, the pipe material and what the wall or floor is made of. A 32mm waste through a 100mm block wall is one product. A 160mm stack through a 200mm slab is another. Plastic pipes need something that closes the bore. Copper or steel pipes do not melt, but they carry heat, so the gap round them is filled with a tested sealant and sometimes the pipe needs lagging for a length either side.

Lambeth has a lot of converted houses where the soil stack was replaced in plastic during the conversion and the hole cut through the old timber floor was never closed. Timber floors need products tested in timber, not concrete. A collar fixed with screws into a floorboard is a different detail.

How it is recorded

Each pipe seal gets its own label and a photo. The schedule line reads something like: 14, kitchen riser 2F, 110mm PVC soil, collar under slab, 60 minutes, photo 14. If a pipe is later replaced, the plumber can see from the label that the collar has to go back on.

The work is done by our BM TRADA / FIRAS-certificated contractors. Pipe work is usually part of a wider job, and a job with us starts at around £2,000 plus VAT.

Seen a hole round a pipe or cable?

Send the postcode and a photo with a tape measure in shot. We will tell you what it needs and what it is likely to cost.

Call 020 3772 6233Get a quote