Can residents stay in during fire stopping?

  • Every seal labelled and photographed
  • BM TRADA / FIRAS-certificated contractors
  • Written price before any work
Get a price

We reply with a written price.

We use these details to reply to you. See our privacy notice.

Yes, for most of it. In a block of flats nearly all fire stopping happens in risers, meter cupboards, corridor ceilings, the bin store and the plant room. Nobody needs to leave their flat for any of that.

Noise is low. Batt is cut with a long knife or a fine handsaw. A collar takes a drill for a few seconds per fixing, three or four fixings a pipe. Mastic goes on with a gun. The dustiest part is digging old foam and broken mortar out of a hole, and that stays inside the cupboard with a dust sheet over the floor.

Collars under a slab are the exception. The fixings go into the ceiling of the flat below, so somebody has to let the contractor into that bathroom or kitchen for twenty minutes or so. The agent writes to those flats with a date, and a second date is held for anyone who is at work.

Riser cupboards with live cables in them are worked on with the cables left live where the batt can be fitted round them. If cables need moving apart on an old riser, the managing agent may want the supply off first, for an hour or so, on a date residents are told about.

Red cables on a steel strut bracket running up to a white board at the top of a wall
Red cables on a steel strut bracket running up to a white board at the top of a wall
Seen a hole round a pipe or cable?

Send the postcode and a photo with a tape measure in shot. We will tell you what it needs and what it is likely to cost.

Call 020 3772 6233Get a quote